Wind Generators

D-400 Replacement Blades (ea)

more

Nose cone for the D-400 Wind Generator more

Tail assembly w/fasteners more

Air Hus assembly kit, contains Hub center w/bolts, plates w/bolts, locking ring and loc-tite more

6TB Eclectic - Regulator w/diversion load - For use with all batteries including lithium - Available in 12 or 24 volts more

NCHC-60 by Flex-Charge has been modified to work with the D-400 wind generator - Available in 12 or 24 volts more

D-400 Main Shaft seal & Bearing Kit more

D-400 Yaw Shaft Bearing & Seal Kit more

D-400 Diversion Load/Resistor Bank/Heat Sink/cover more

D-400 Main Shaft more

D-400 Brush Replacement Pack more

D-400 Aluminum Blade Lock Ring more

The Tower liner is the bushing the is inserted in the pole and connects to the generator. more

Yaw shaft with slip rings assembled more

Rectifier Kit more

Center hub with bolts (New) more

Screw in 12 volt hot water heater element 600 watt that can be used as a diversion load NOTE: This item is only a replacement heating element and provides no ... more

This item has been designed to be a drop-in replacement for the heating element that exists in the Marine hot water tank. It fits into a 1 inch opening and ... more

D-400 wind generator - Replacement blade set (set of 5)

more

D-400 wind generator - replacement blade set (set of 5) and one nose cone

more